Xprog manual: how to read CEM units from Volvo S40/V50/C30/C70 2004- It’s Xprog working for Volvo S40/V50/C30/C70 2004- Xprog-box 5.7.0 Xprog-m 5.6.0 It is CEM unit used on S40/V50/C30/C70 2004- This CEM has already get clone in a company. open it up and saw 5 soldering spots to the left from Continue Reading →
This WinKFP job was done with ICOM A2 emulator for FRM3 flash after FRM3 repair/reflash by Xprog-m or other programmer the like. After FRM3 was repaired, then need to flash the correct software in FRM3 module. The flash can be done with WinKFP, and in 2 ways. Comfort mode and develop mode! The Continue Reading →
Got one XPROG-M V5.55, when I installed, I got error message “Access violation at address 1104DF84 in module ‘argen .dff”. read of address 7a6bee7b”. I changed operation system, but failed again, this error message not disappear. Working solution by cardiagtool.co.uk: Check if you install to Continue Reading →
News for you! We tested XPROM V5.6.0 is operating fine to read write ECU data, and only takes 3 steps to install. So how to install XPROM V5.6.0? There are several main steps. Install Adobe Reader Registry editor Install device driver software Copy read write device data OS: XPROM V5.6.0 is ope Continue Reading →
UPA-USB VS XPROG-M Item Number SM48 SE100-B Item Name XPROG-M V5.5.5 with USB Dongle +T420 Laptop +500GB HDD UPA USB 2014 with Full Adaptors Software Version V5.5.5 V1.3.0.14 Hardware Version 2015 2014 Update No No Language English English/Russian with Dongle Continue Reading →
XPROG-M difference: Item Number SM48 SM48-B SM44-C SM11-D SM11-F SM11 Item Name XPROG-M V5.5.5 with USB Dongle +T420 Laptop +500GB HDD XPROG-M V5.5.5 with USB Dongle XPROG-M V5.50 without USB Dongle Xprog-m V5.3 with USB Dongle XPROG-M V5.3 Main Unit XPROG-M V5.0without USB Dongle Version Continue Reading →
The EU version ATMEGA64 is tested working stably to update XPROG-M Programmer V5.55 from any of V5.0, V5.3, V5.45 and V5.50. It avoids the software problem bothering that most customers met before. Package: This package only includes ATMEGA64 Repair Chip and software, not include Xprog hardwar Continue Reading →
ATMEGA64 Repair Chip Update XPROG-M Programmer from V5.0/V5.3/V5.45/V5.50 to V5.55 Full Authorization (Including CAS4) with Stable Software Top 3 Reasons to Buy this Update chip and Software: 1. European solution on XPROG-M software, tested for all versions, very reliable. 2. Support any XPROG-M Continue Reading →
Xprog M V5.51 ECU Programmer Software download Xprog-m box software version 5.51 ,only use our software-CD, the hardware will be damaged without any warrany, cannot be repaired if you use other version software(lower or higher) or try to update the software or hardware. Attention for xprog-box 5 Continue Reading →
