One customer shared his experience about Ktag ECU programmer. He used Ktag to read and write Micro, Flash and eeprom on Mercedes Benz M112 engine ECU successfully.
Here is his operation process.
Connect the Ktag and Benz M112 engine according to the pinout in the ktag software V2.23
Pin 5/ Continue Reading →
I took some time to do a little review of these BDM connectors (China) for Ktag 2.23
I have already received the shipment and I have time to test them without problems in Bosch EDC16U1 and in bosch EDC17c46. before using them I have reviewed almost all of these and I have not had any probl Continue Reading →
PCR2.1 Read/Write with Ktag:
Tricore BOOT Simos PCR2.1 adapter
Move the retainer carefully, towards the ECU and ensure that all pins are in their designed position
To read EEPROM and unlock ECI, switch the adapter in BOOT mode
Turn ECU power off before switching the mode
Disconnect power fro Continue Reading →
Most comprehensive advice on what ECU programmers clone are verified working fine and good investment, tools advice including Kess v2 master fw v5.017/4.036, Ktag master V4.036/ V4.024 truck version, Fgtech Galletto V54, MPPS. Starts from the basic info comparison, advice which are really good a Continue Reading →
What is the difference between Chip Tuning and ECU Remapping? The difference is basically the age of the techniques used to obtain the cars “map file”. Nowadays you are very unlikely to get your car “chipped” due to the evolution of electronics and chips themselves. Basically, chip tuning is Continue Reading →
To answer this question, many opinions show on forum. People recommend KTAG, KESS V2, FGtech V54 no checksum error! Check their reasons below to know more:
Most tools do checksum after reading ECU , KESS KTAG FGTECH MPPS. I bought a useful tool kit: KTAG plus KESS V2 with ECM TITANIUM 1.61 Continue Reading →
To all ECU tunners and Ktag Master users:
Ktag Master V7.003 update to Ktag Master V7.020!
Ktag Master V7.020 Works:
Many encrypted new car models works I.E Toyota 76FXXX, PSA 17.4.4, Ford E83, VW 17.5.5 (1766), Mercedes-Benz 276ECU, Toyota 76F, etc.
100+ ECU types works (The list is gath Continue Reading →
Free download Ktag/ Kess V2 software Ksuite v1.93, which can solve:
– error “Tool is not updated”
– ktag/kess not working with gray buttons
Part 1: Kess v2 Ktag v1.93 download on Mega
Working ok with:
SE87 Continue Reading →
Tips from pros here, about a ecu programmer comparison tablet, incl. MPPS v18, ktag, kess, fgtech galletto 4 or fgtech2… Mainly differs from communication/ protocols. Hope this helps.
Mpps v18 vs. Kess v2 vs. K-tag vs. Fgtech
Continue Reading →