Korhex How-To: Essential Technical Tips for Proper Positioning and Better Glitch Execution

A Practical Guide to Getting the Most Out of Your Korhex

The Flex Korhex Fault Injection Tool is designed to tackle heavily encrypted modern ECUs by injecting electromagnetic faults to bypass password verification. However, achieving consistent glitch execution requires more than just a high-performance device. Correct antenna alignment, proper contact, and accurate positioning are equally important.

Even a small positioning mistake can affect the glitching process or, in the worst case, cause irreparable damage to the microprocessor.

In this guide, we’ll walk you through the essential DOs and DON’Ts to help you use Korhex correctly, improve connection accuracy, and get the most out of your device.

korhex essential technical tips for proper positioning and better glitch execution

1. Check Your Antenna Alignment

One of the most important factors in successful glitch execution is the antenna’s actual orientation.

Keep the Korhex device body perpendicular to the MCU (Microcontroller Unit), but don’t rely solely on the device’s angle. You must also verify that the antenna is correctly aligned with the designated contact point on the processor.

Depending on the antenna’s geometry and mounting position, keeping the device perpendicular may not always guarantee correct antenna alignment.

Key tip: Always check the antenna’s actual orientation rather than judging its position by the Korhex body alone.

2. Ensure Correct Antenna Contact

Proper antenna contact with the intended processor surface is essential for consistent glitch execution.

Before starting, make sure the antenna is correctly positioned against the designated MCU area. Incorrect contact or misalignment may lead to inconsistent results.

Take your time to check the contact point and ensure the antenna is positioned as intended before proceeding.

3. Use the Correct Positioning Mask

Positioning masks help maintain accurate and stable antenna placement during operation.

You can purchase dedicated positioning masks from our shop or 3D-print them yourself by downloading the corresponding STL file directly from Flex software.

When using a positioning mask:

  • Make sure the mask is positioned correctly.
  • Do not turn the mask upside down.
  • Follow the guided instructions for proper installation.
  • Use only dedicated positioning masks between the antenna and the MCU.

If glitch execution is inconsistent, recheck the antenna alignment and adjust the device’s position as appropriate.

korhex essential technical tips for proper positioning and better glitch execution 1

Korhex DON’Ts: 3 Common Mistakes to Avoid

To help prevent positioning errors and potential hardware damage, keep these three important precautions in mind.

1. Don’t Tilt the Korhex Device

Always keep the Korhex body perpendicular to the control unit. Avoid tilting the device during operation, as incorrect positioning may affect antenna alignment.

2. Don’t Install the Positioning Mask Incorrectly

Check the orientation of the positioning mask before use. Never turn it upside down, and always follow the guided instructions to ensure correct placement.

3. Don’t Place Objects Between the Antenna and MCU

Never place unnecessary objects between the antenna and the MCU. The only exception is a dedicated positioning mask designed for this purpose.

korhex essential technical tips for proper positioning and better glitch execution 2

Important Safety Reminder

Incorrect antenna positioning can cause irreparable damage to the microprocessor. Before performing any glitch operation, carefully verify the antenna orientation, contact point, and positioning mask.

Never rush the setup process. A few extra moments spent checking the positioning can make a significant difference in achieving consistent glitch execution and protecting the ECU.

Video Guide:

Remember: Correct angle, proper contact, and accurate positioning are the keys to a successful Korhex setup.

 

UK Professional OBD2 Tools Online Shop

(Visited 1 times, 1 visits today)