Question: I’m gonna read and write Hyundai KEFICO CPEGD2.20.3 TC1782 ECM, which OBDSTAR Tool can I use? Eobdtool.co.uk gave the suggestion below: Both OBDSTAR DC706 ECU Tool and X300 Classic G3 added this car model in the ECM V30.80. They can read and write Hyundai KEFICO CPEGD2.20.3 TC1 Continue Reading →
OBDSTAR DC706 ECU Tool can read and write INT Flash and INT EEPROM, read IMMO data, decrypt IMMO Data, convert (clone) INT EEPROM Data, calibrate mileage to AUDI MED17.1 TC1796 ECM by Bench and MP001 or P003/P003+ mode. You don’t need to connect a 120-ohm resistor if you use the MP001 connection Continue Reading →
OBDSTAR DC706 with ECM V30.70 can read and write Volkswagen 7GV ECM EXT EEPROM (95320), read IMMO data and do IMMO OFF in Bench mode successfully. OBDSTAR P004 Adapter & ECU Clone Jumper, main cable and 12V power supply are required for this function. Operation guide: Select ECU Flasher>& Continue Reading →
Sometimes, Mercedes-Benz A-Class, B-Class, and GLA-Class vehicles may experience a situation where the car can be started but cannot be put into gears. This is caused by a loss of transmission ECU data due to a discharged car battery. The fault codes read with a diagnostic tool will reveal DTC P0 Continue Reading →
OBDSTAR DC706 with ECM V30.61 (newest) can read and write Flash and EEPROM data for Smart EDC16C32, EDG15C-5.X KLINE, ME17.9.20 and ME7.7.0 KLINE ECMs on Bench. Some support Boot and OBD modes as well. Check the support list below carefully. BRAND ECU BRAND TYPE DUMP R & W INT flash R &a Continue Reading →
It has been tested and confirmed by OBDSTAR Tech that OBDSTAR DC706 ECU Tool has the ability to read and write VW SIMOS18.10 & SIMOS10.22 ECMs in Boot mode. It’s simple and fast to operate with the wiring diagram and instruction in the device system. Only need 2-3 minutes! 1.OBD Continue Reading →
How about OBDSTAR DC706 ECU Tool? Compared with IO Terminal, any good? DC706 has full clone function. It supports ECM, TCM and Body/other system clone via OBD or Bench. It can read ECU info, R/W Eeprom/Dflash/Pflash/MAP, reset ECU (Virgin), calibrate mileage, read IMMO pincode, and recover ECU&# Continue Reading →
Question: Is it possible to read and write Renault Siemens SIRIUS 32 ECM with OBDSTAR DC706? via OBD or bench? Here is the answer. Yes. DC706 ECU Tool can read and write some Renault ECMs via OBD/Bench/Boot. Not one model supports all three operations. Only CONTINENTAL EMS3110 supports Boo Continue Reading →
How to use OBDSTAR DC706 ECU Tool to clone Land Rover ZF 9HP TCM on bench? The device software has operation guide and Pinout to help customer perform this function. Just Keep DC706 charging and communicating throughout the whole progress, and make sure the network connection is normal as well. Continue Reading →
