Alientech KESS3 recent update brings a new Continental SID321 ECU (OBD/Bench mode). Tested on a Sid321 Nissan Navara all good. Working perfectly by OBD and bench. Did Navara 2021 in bench mode, made one file revision again on bench. Then cosutomer asked to add egr off also, couldn’t conne Continue Reading →
Alientech KESS V3 ECU Programmer with the advanced DynoDrive function allows customers to calculate and verify while driving a vehicle. The DynoDrive feature can be activated by all users with the KESS3 Master Version and Slave Version and does NOT require an active subscription. It can also be a Continue Reading →
Dear new and old customers, Alientech is releasing a big sale for KESS V3 ECU Programmer now. Purchase KESS3 Master Version and Car LCV OBD-Bench-Boot Protocols Activation at about 50% off! Valid date: from July 22nd to August 31st, 2024! Don’t miss it! 1.If you have bought a KESS3 M Continue Reading →
As we know, Alientech Kess3 ECU Programmer can support car/motorcycle DTC diagnosis and reset through the EOBD connection since June 27th, 2024. Just ensure the device is under software subscription. Let’s see how to use this new DTC function on BMW with Kess3. Quick start guide: Conn Continue Reading →
Good news!!! Alientech Kess V3 ECU Programmer added a new DTC Feature: Diagnostics and DTC Reset. No matter the new and old customers, you can free update this new feature. Just make sure your software subscription is available. DTC Feature Detection and reset of DTCs with KESS3. A new feature Continue Reading →
Alientech KESS V3 ECU Programmer released a new upgrade on May 15th, 2024. Now it can work on the Mitsubishi ECUs like 21175-0254, 32920xxx, 21175xxx installed on Kawasaki, Suzuki, and Yamaha motorcycles and ATVs by Bench. Update details: Elevate customer satisfaction with seven new protocols t Continue Reading →
Alientech KESS V3 ECU Programmer released a new upgrade on May 2nd, 2024. Now it can read/write Isuzu N-Series Truck with Denso 276700-2051 ECU in bench mode. Update details: Work on bench in “BENCH” mode for tuning, optimizing fuel consumption, and repairing Isuzu N-Series trucks equipped wi Continue Reading →
KESS3 Frequently Asked Questions 1. How can I interface and program the control units? With KESS3 you can program the engine control units (ECU) or transmission control unit (TCU) in three different ways: OBD – With the OBD mode, you can easily access all the ECU data through the diagnostic soc Continue Reading →
Alientech Kess V3 ECU Programmer released a new upgrade on April 10th, 2024. Thanks to this new development for KESS3, you can remap via OBD the Bosch MSE8.0 engine control unit installed on CF Moto’s CForce range models and Zontes’ small-displacement ZT models. New ECU: Bosch M Continue Reading →
