Foxflash ECU Chip Tuning Tool adds a new exclusive protocol in the newest software on May 23, 2023. After upgrade, you’ll find the BENCH protocol for Isuzu EDC17C83. Foxflash update info: Bench/Boot protocol for Isuzu EDC17C83. Supported Control Units & Vehicles: ECU: Bo Continue Reading →
Confirmed! OBDSTAR DC706 with ECM V30.07 (newest software) can clone Jeep and Fiat IAW 10GF ECMs on Bench perfectly. OBDSTAR P003 Adapter, 12V power, and internet are required. Make sure the internet connection is normal during the operation. 1.OBDSTAR DC706 Clone Jeep IAW 10GF ECM Devic Continue Reading →
Here shares the solution to fix foxflash error “EXECUTE DOWNLOAD WITH DFBTech_UPDATER FOR TOOL RE-ESTABLISHMENT” when downloading the software to a new computer. The solution: Make sure the following items are performed: 1. Turn off Defender 2. Set Date/time sync off (When you click ACT Continue Reading →
OBDSTAR MT200 is a portable and cost-effective handheld radio decoding tool to perform EEPROM read & write, code read & change & off and other functions by OBD or Bench for Ford, VW, etc. The Pincode of Radio can be queried by OBDSTAR APP (according to the SN of Radio). Here takes For Continue Reading →
Foxflash ECU Chip Tuning Tool can support JTAG/BDM mode for Denso ECUs reading and writing. Just need to open the ECU and connect it with the JTAG/BDM adapter. Sometimes, it cannot work normally. The possible cause is the ribbon cable is not correctly orientated. How to fix this problem if it app Continue Reading →
The Foxflash ECU Programmer can support FCA GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot mode since March 14, 2023.Click here to check the detailed ECU models. Today we’ll share the Pinout to these ECUs. BAM SPC5674 CONTINENTAL GPEC2A FCA Pinout Connect with the multifunction Continue Reading →
One customer reported that he cannot read the Kia edc17cp14 by using PCMTuner with 71 module in bench mode. He tested on many ECUs but no results. Here is the suggestion from eobdtool.co.uk engineer. The following edc17cp14 pinout is for Hyundai/Kia. Do not try to read until the ID is successfu Continue Reading →
Some customers give feedback that they can use PCMTuner ECU programmer to read and write PSA EDC17C60 car, the car starts the first time and then never starts again, also appears the fault code “P151A 92” and “P3028 00” as shown in the following figures. Here is the solution provided Continue Reading →
Is it possible to use Foxflash ECU Programmer to read and write Renault sid310? via OBD, bench or boot? Here is the answer. OBD and Boot mode both are OK. 1.OBD Driver for Renault Master SID310 is available in foxflash software. 2.Renault sid310 with foxflash by Tools Boot mode Fin Continue Reading →
