Magic Motorsport has released Flex Version 8.24.0.0, bringing a new OBD programming solution for Keihin KTKSv2 ECUs equipped on selected Triumph motorcycles. With the new protocol, technicians can connect directly to the diagnostic port of the vehicle and perform writing operations in OBD mode, w Continue Reading →
Magic Motorsport has released Flex software version 8.23.0.0, bringing a new Boot Glitch solution for Stellantis Group Bosch MD1CS003 ECUs. The new procedure uses Korhex together with EMFI (Electromagnetic Fault Injection) technology to work with the TC298 processor. This update provides a pract Continue Reading →
Magic Motorsport Flex version 8.21.0.0 is now available, bringing a useful new programming solution for BMW Group vehicles equipped with the Bosch MG1CS003 ECU. Equipped with an SPC5777M processor, the Bosch MG1CS003 control unit can now be programmed directly in Bench mode, no need to open the Continue Reading →
Mercedes Truck CPC5 control units installed on vehicles produced after 2020 are now among the new units supported by Flex + Korhex. Together with the Korhex accessory, Flex can now access these latest CPC5 units using an advanced Boot Glitch procedure based on EMFI (Electromagnetic Fault Injectio Continue Reading →
A new user report confirms successful Magic Motorsport FLEX Boot Glitch unlocking and reading on a BMW Bosch MG1CS024 ECU. The ECU was successfully unlocked using the glitch method, with the unlock process taking approximately 1 hour in-house. After unlocking, the ECU could be read and written di Continue Reading →
Magic Motorsport has released Flex Version 8.14.0.0, bringing new programming opportunities for the motorcycle market. The latest update introduces Bench support for Marelli MBC1 and MBC2 XC20xx control units installed on selected BMW Motorrad and Husqvarna motorcycles. With the new Bench protoco Continue Reading →
For modern BMW B48, B57, and B58 engines, working with encrypted Bosch MD1 and MG1 ECUs equipped with TriCore AURIX TC2xx processors such as TC298 and TC299 can be made much easier with FLEX. The process is completed in two stages: first, perform the initial Boot Glitch unlock on the bench by ope Continue Reading →
Flex support for the VAG Group expands even further. With version 8.13.0.0, it is now possible to program the Bosch MG1CS111 ECU, equipped with a TriCore TC298 processor. Thanks to Boot Glitch unlocking, it is possible to work on the ECU completely independently, including in Bench mode, without Continue Reading →
Magic Motorsport Flex users can now unlock locked Bosch MD1 MG1 ECUs directly using Boot mode, eliminating external RFT service dependencies for bench reading and writing. Technical Overview This protocol enables direct Boot mode unlocking on Bosch MDG1 Engine Control Units equipped with Tri Continue Reading →
