The newest software of Foxflash ECU programmer was updated on September 06, 2023. It added BMW, Mini, Citroen, and Peugeot Bosch MEVD17.2.7 read and write via Bench and Boot mode. Update info: BMW MINI BENCH BOOT READ&WRITE September 06, 2023 BMW INSTALL Bosch MEVD17.2.7 Bench read/write &nb Continue Reading →
Customer problem: When I used foxflash ecu programmer to read and write ECU, the software suddenly crashed. I restarted the software to try again, but still appeared the same problem. Eobdtool.co.uk engineer’s solution: Please follow the steps below to enable Administrator elevated Privil Continue Reading →
Here shares the newest user feedback about on FoxFlash full read and write Toyota Denso NEC76F00XX BDM with 14V better supply. * Denso NEC76F0038AGD 175822-762 Toyota * Denso NEC76F0038AGD 175822-773X Toyota * Denso NEC76F0038AGD 175822-887 Toyota * Denso NEC76F0038AGD 211941-37900830 Toyota * D Continue Reading →
Foxflash software newest update on September 14, 2023: Fixed checksum for Bosch MED17/EDC17 incl. MCU TC1766 TC1793 TC1797 TC1724F TC1767 Update details: foxFlash is now able to perform the following operations: Software calculate checksum On the following ECU reference: Audi Bosch MED17.5 TC176 Continue Reading →
Launch X431 X-Prog3 PC Adapter with PC software can work with Launch X-Prog3 Immobilizer Programmer to perform ECU read and write, data processing, anti-theft shutdown and file verification. For the first time using it, it requires you to download, install PC software and activate the device. X4 Continue Reading →
One customer failed to download Foxflash software and got the error “Unhandled exception in the application. If you click Continue, the application ignores this error and attempts to continue. If you click Exit. The application will close immediately. Could not read block- no data!” He asked “ Continue Reading →
The newest software of CG100 Prog III is updated to V6.7.3.0 on Aug.29th, 2023. Here share the related update info and the available mega link to download free. CG100 PROG III V6.7.3.0 free download link: https://mega.nz/folder/3CIXXDJC#jJ4CdJ9T-eEYhkBYi6Z65A/file/DG53CA5I Update details: 1.Adde Continue Reading →
If this is your first time using Launch X-431 ECU & TCU Programmer for ECU/TCU reading/writing, data processing, anti-theft shutdown or file verification, please follow this post to download, install, update, and activate the device step by step before operation. Kindly notice: X431 EC Continue Reading →
Here is the newest customer feedback about Foxflash ECU Chip Tuning Tool. edc15 P+ BENCH Flash & eeprom Start EDC15C3 (bench)– from Renault Laguna/ Read/Write OK EDC15C13 (bench) — from Espace IV/ Read/ Write OK EDC15C4 Full Flash R/W OK – obd-bench with 12v edc15c13 renault BENCH Flash&a Continue Reading →
