Confirmed! OBDSTAR DC706 with ECM V30.07 (newest software) can clone Jeep and Fiat IAW 10GF ECMs on Bench perfectly. OBDSTAR P003 Adapter, 12V power, and internet are required. Make sure the internet connection is normal during the operation. 1.OBDSTAR DC706 Clone Jeep IAW 10GF ECM Devic Continue Reading →
Here shares the solution to fix foxflash error “EXECUTE DOWNLOAD WITH DFBTech_UPDATER FOR TOOL RE-ESTABLISHMENT” when downloading the software to a new computer. The solution: Make sure the following items are performed: 1. Turn off Defender 2. Set Date/time sync off (When you click ACT Continue Reading →
OBDSTAR MT200 is a portable and cost-effective handheld radio decoding tool to perform EEPROM read & write, code read & change & off and other functions by OBD or Bench for Ford, VW, etc. The Pincode of Radio can be queried by OBDSTAR APP (according to the SN of Radio). Here takes For Continue Reading →
Foxflash ECU Chip Tuning Tool can support JTAG/BDM mode for Denso ECUs reading and writing. Just need to open the ECU and connect it with the JTAG/BDM adapter. Sometimes, it cannot work normally. The possible cause is the ribbon cable is not correctly orientated. How to fix this problem if it app Continue Reading →
The Foxflash ECU Programmer can support FCA GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot mode since March 14, 2023.Click here to check the detailed ECU models. Today we’ll share the Pinout to these ECUs. BAM SPC5674 CONTINENTAL GPEC2A FCA Pinout Connect with the multifunction Continue Reading →
Is it possible to use Foxflash ECU Programmer to read and write Renault sid310? via OBD, bench or boot? Here is the answer. OBD and Boot mode both are OK. 1.OBD Driver for Renault Master SID310 is available in foxflash software. 2.Renault sid310 with foxflash by Tools Boot mode Fin Continue Reading →
Here are three new problems and solutions for Foxflash ECU Programmer. Problems: Problem 1: Value of 25/9/2022 is not valid for “Value” Problem 2: The application was unable to start correctly Problem 3: An error occurred while trying to download file The solutions offered by e Continue Reading →
Some customers ask how to use Foxflash ECU programmer to clone Benz VGS3, Audi MED9.1, and VW MED17.1 successfully. Here are tips offered by eobdtool.co.uk engineer. 1.For Mercedes- Benz VGS3 (on bench) Use FoxFlash to copy the VIN and SCN string then write into the new VGS. And need to e Continue Reading →
The newest Foxflash software is released on March 14, 2023. Now it is able to perform the Continental GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot. Update method: Try to update just connect, run Foxflash Manager and activate it. No need to download, because the protocols are in Continue Reading →
