V13.02 MPPS Chip Tuning Software Installation Tips
MPPS chip tuning V13.02 is a common auto ecu programming tool, also a hot-selling device with only €13.50 on obdtool. MPPS ECU flasher supports flash reading and writing, recalculation of checksum via the diagnostic connector.
obdtool additionally offers 3 kinds of MPPS chip tuning tools, please check below:
ECU Chip Tuning Tool v13.02 Pre-installation Notices:
- The software version you install show V13.02, while shown as V12 after successful installation;
- Please install the driver well; the install drive file is under the installation directory;
- Required OS system: Windows XP SP2
- The MPPS Software will not start unless a valid MPPS Cable is plugged into and the driver has been successfully installed.
MPPS V13.02 software installation instructions:
Save the file to your disk;
Run the “Mpps_Setup.exe”. (Note: Windows 7 Users will be prompted “Do you want to allow the following program to make changes to this computer?” >> Just click “Yes”);
Select language you want and click “NEXT”;
Click “Next” to proceed;
Check the box “I accept all the terms of the license agreement”, click “Next”;
Installation will proceed;
Click “Finish” to complete the installation.
You can find on the following page the supported car K-line/CAN or further information on MPPS chip tuning: