2018 Xprog M V5.84 firmware V4.4, with USB dongle, adds new authorizations: AUTH-0028-1 Renesas V850 Authorized and AUTH-0028-2 Renesas SuperH Authorized 2017/10/9. XPROG-M V5.84 Authorizations: AUTH-0001 Motorola HC05 family authorization (allows to read/write EEPROM) AUTH-0002 Continue Reading →
I’d like to show you how to read EWS3 0D46J from BMW E39 using a Xprog-M programmer. The EWS 3 Immobilizer unit , in the BMW E39 car body, is above the pedals, on the left. remove it. take the board out of the case. The immobilizer is assembled on a Motorola microcontroller with a m Continue Reading →
Before sending the package to users, Kess V2 5.017 will be tested and checked to pass the QC test. Here presents the Kess V2 5.017 Online Version Green PCB in QC test. 1.Open the box, today the QC guys will test more than 100 pieces of Kess V2 5.017 Online Green PCB. 2.Plug the 1 Continue Reading →
Guide to help you read data of mb91f061bs from Suzuki Jimmy 2016: Option 1: Usa X100 DP por OBD. Option 2: Sino X300 Plus Option 3: VVDI-Prog Xhorse you can refer to following information. MD0114 DUIN 121 DUOUT122 RESET107 GND11411375272109116119129(any of them ok) VCC1103651108128(a Continue Reading →
Hello bros. I’ll chime in with my experience of ktag clone checksum error: in Ktag slave (full backup) ver – read and write ok in Ktag master – if i want to read only flash (ex. sid 803) or micro (ex. edc17cp14) at end of reading 99% it write checksum error and every file i Continue Reading →
Ktag 7.020 Red PCB Backup, Restore, Read and Write: Select the proper Family, then: Click on Help for the see the connection instructions. Connect to the ECU following the connection instructions provided in the Operating Manual. Once back to the previous window, Click on OK to display the prog Continue Reading →
Good News!!! MPPS V18 software is compatible with the MPPS V21 hardware; MPPS V21 software is compatible with the MPPS V18 hardware; MPPS V21 software and MPPS V18 software can share the same hardware. Most importantly! the hardware WON’T BE LOCKED any more Anyway, there are a Continue Reading →
SD-cards provided with KESS and KTAG don’t meet the standards to be able to have a serial number (CID) identical between them. Indeed, for the KESS or KTAG to work, the contents of the SD-cards must be encrypted in relation to its CID. Speed is not the most important. But a SD card with a wr Continue Reading →
After tested, Carprog V10.93 full software works great with Carprog V8.21 interface and the cheaper version interface. The detail installation guide and software download link will be posted below. * Install Carprog full software V10.93 on the firmware V8.21 interface Producer: engineer T Continue Reading →
