One customer shared his experience about Ktag ECU programmer. He used Ktag to read and write Micro, Flash and eeprom on Mercedes Benz M112 engine ECU successfully. Here is his operation process. Connect the Ktag and Benz M112 engine according to the pinout in the ktag software V2.23 Pin 5/ Continue Reading →
bennyboi2005: Used on edc17c19 no issues Bomgar: Here have collected a lot of feedback about what can or cannot work with KTM Bench ECU programmer. Thanks to all the users who gave real reviews on the mhhauto forum. raull00: I do edc17cp20 work very good I did iveco EDC 17C49 2017 ok boot jumpe Continue Reading →
This blog will totally make you clear: What’s the difference KTAG FW 7.020 vs. KTAG 7.003 vs. KTAG 6.070? Which ECU types are newly supported? Check below KTAG FW 7.020 Ksuite V2.23 screenshots! In general, KTAG Firmware 7.020 add more than 100 ECU protocols newly supported. Here yo Continue Reading →
New KTAG Firmware 7.020 Ksuite 2.23 is now available! This blog will show you how to install Ksuite 2.23 software for KTAG FW 7.020 with step by step! Better install it on Windows XP. Note: Before install, please disconnect the internet connection. Below installation guide is only used for Continue Reading →
Free download Ktag/ Kess V2 software Ksuite v1.93, which can solve: – error “Tool is not updated” – ktag/kess not working with gray buttons Part 1: Kess v2 Ktag v1.93 download on Mega https://mega.nz/#!f8xQGLRA!8ZNod0YLAI-bY0rezjpthlBxyg-lzMSWnZCBoreCUuY Working ok with: SE87 Continue Reading →
