Sometimes, Mercedes-Benz A-Class, B-Class, and GLA-Class vehicles may experience a situation where the car can be started but cannot be put into gears. This is caused by a loss of transmission ECU data due to a discharged car battery. The fault codes read with a diagnostic tool will reveal DTC P0 Continue Reading →
Alientech KESS V3 ECU Programmer released a new upgrade on May 15th, 2024. Now it can work on the Mitsubishi ECUs like 21175-0254, 32920xxx, 21175xxx installed on Kawasaki, Suzuki, and Yamaha motorcycles and ATVs by Bench. Update details: Elevate customer satisfaction with seven new protocols t Continue Reading →
OBDSTAR DC706 with ECM V30.61 (newest) can read and write Flash and EEPROM data for Smart EDC16C32, EDG15C-5.X KLINE, ME17.9.20 and ME7.7.0 KLINE ECMs on Bench. Some support Boot and OBD modes as well. Check the support list below carefully. BRAND ECU BRAND TYPE DUMP R & W INT flash R &a Continue Reading →
Professional DPF+EGR REMOVER 3.0 Lambda Hotstart Flap/O2/DTC 2 Software Full Version Solfware Free Download 1. The software is compatible with FGTECH Galletto, KESS V2, KTAG Master, MPPS, CMD ect. Readers – file writers who work 100% with these programs. 2. Professional DPF-EGR programs sup Continue Reading →
How to use CG FC200 to read and write Volvo Denso MB279700xxx ECU? Check the tips and guide below. 1.Update your FC200 software to V1.1.7.0 or above FC200 V1.1.7.0 added Volvo Denso models MB279700-9500, MB279700-9801, and MB279700-9811 read and write function (platform) Free download Continue Reading →
Alientech KESS V3 ECU Programmer released a new upgrade on May 2nd, 2024. Now it can read/write Isuzu N-Series Truck with Denso 276700-2051 ECU in bench mode. Update details: Work on bench in “BENCH” mode for tuning, optimizing fuel consumption, and repairing Isuzu N-Series trucks equipped wi Continue Reading →
KESS3 Frequently Asked Questions 1. How can I interface and program the control units? With KESS3 you can program the engine control units (ECU) or transmission control unit (TCU) in three different ways: OBD – With the OBD mode, you can easily access all the ECU data through the diagnostic soc Continue Reading →
It has been tested and confirmed by OBDSTAR Tech that OBDSTAR DC706 ECU Tool has the ability to read and write VW SIMOS18.10 & SIMOS10.22 ECMs in Boot mode. It’s simple and fast to operate with the wiring diagram and instruction in the device system. Only need 2-3 minutes! 1.OBD Continue Reading →
How to use Launch X431 ECU & TCU Programmer to clone KIA MEG17.9.12 TCU on Bench? Check the step-by-step guide below. Connect X431 ECU Programmer to a computer via USB cable Run X-431 ECU & TCU Programmer software Input meg17.9.12 in the search box to quickly find Kia Cee’ d20 Continue Reading →
