Autotuner first introduced support for BMW DME8 ECUs in 2019. However, a software update released by Bosch and BMW in 2020 reintroduced security restrictions, preventing technicians from accessing these ECUs for reading and writing operations in the field. Access is now back, and you can get star Continue Reading →
Magic Motorsport has released Flex Version 8.24.0.0, bringing a new OBD programming solution for Keihin KTKSv2 ECUs equipped on selected Triumph motorcycles. With the new protocol, technicians can connect directly to the diagnostic port of the vehicle and perform writing operations in OBD mode, w Continue Reading →
Here is a simple way to read Bosch MED17.8.10 ECU data on bench using Xhorse Multi-Prog and GODIAG guidebook. Preparation: Xhorse Multi-Pro Programmer GODIAG Xhorse MultiProg Mastering Programming Book GODIAG ECU GPT Boot AD BOSCH MED17.8.10 ECU Windows PC Procedure: Open Mu Continue Reading →
Magic Motorsport Flex Hyundai MD1CS012 Boot Glitch connection issue? Here’s a useful tip: use good-quality cables and keep them as short as possible. The FLX4.1 cable can be too long for this ECU, so soldering short wires directly to the PCB can help establish a stable connection. Example: Hyund Continue Reading →
Magic Motorsport has released Flex software version 8.23.0.0, bringing a new Boot Glitch solution for Stellantis Group Bosch MD1CS003 ECUs. The new procedure uses Korhex together with EMFI (Electromagnetic Fault Injection) technology to work with the TC298 processor. This update provides a pract Continue Reading →
Problem:An Magic Motorsport Flex user attempted to read a Delphi ETC3 ECU via OBD, but the tool failed to establish communication and displayed the message: “UDS version is not supported yet.” The ECU also could not be connected or read successfully in Bench mode. Here is the solution for rea Continue Reading →
Magic Motorsport Flex version 8.21.0.0 is now available, bringing a useful new programming solution for BMW Group vehicles equipped with the Bosch MG1CS003 ECU. Equipped with an SPC5777M processor, the Bosch MG1CS003 control unit can now be programmed directly in Bench mode, no need to open the Continue Reading →
Launch officially released X-431 ECU Clone software V10.75 on September 21, 2026. The update adds new ECU reading, writing, cloning, and immobilizer functions for X-431 X-Prog5, X-431 ECU & TCU Programmer, and X-Prog3 with PC Adapter. What’s New in V10.75? For X-Prog5, the update adds severa Continue Reading →
Yanhua Mini ACDP and ACDP2 now support Bench-mode ISN reading, data reading, and writing for locked BMW gasoline and diesel ECUs manufactured after June 2020, covering popular platforms such as B48, B58, B57, and more. Yanhua B48/B58 Interface Board with A520 License is required. If you already Continue Reading →
