CGDI has released the latest FC200 V1.4.1.0 software update, bringing new ECU read/write support, locked ECU bench functions, Immo Off coverage, and several function optimizations. 1. Added Read/Write Support for the Following ECU Types: Borgward: MED17.8.21 Changan: MT92.1E Buick: GL8 48V (Lith Continue Reading →
XirDecoder has released a new software update adding support for the Bosch MD1CP032 ECU found in BMW vehicles. Supported Solutions The update includes a wide range of tuning and ECU solution options: Stage 1 performance tuning DPF, AdBlue, EGR, CAT, LAMBDA & NOX MAF & TVA Torque Monitori Continue Reading →
Some users have reported that when using the CG FC200 to read Chery, Great Wall, BAIC, Geely, Changan, and other ME7.8.8 / ME7.9.7 / M7.8 ECUs, the operation may fail with an “E121 Version Not Supported” error, prompting you to use BOOT mode. If you encounter this issue, try the following tip w Continue Reading →
AutoTuner All-In-One ECU Tool has released a new software update expanding ECU support for Ford naturally aspirated petrol engines on September 15, 2026. With this update, the Continental EMS2101, EMS2102, EMS2103, and EMS2106 ECUs can now be serviced directly via 100% OBD using the AutoTuner Too Continue Reading →
Dimsport The Genius continues to expand its ECU programming capabilities with new Bench solutions for modern heavy-duty and BMW Group engine management systems. The latest update introduces Bench access to Bosch ECM4 ECUs used on several heavy-duty platforms, as well as a new Bosch MDG1 Bench sol Continue Reading →
Mercedes Truck CPC5 control units installed on vehicles produced after 2020 are now among the new units supported by Flex + Korhex. Together with the Korhex accessory, Flex can now access these latest CPC5 units using an advanced Boot Glitch procedure based on EMFI (Electromagnetic Fault Injectio Continue Reading →
Cloning a Delphi 7.1 ECU requires transferring the original unit’s EEPROM and Flash data to a replacement ECU. Using the Xhorse Multi-Prog programmer, technicians can access the ECU data in boot mode, read the required memory contents, and write them to the donor unit for accurate data transfer Continue Reading →
KESS3 expands the range of operations available on the latest “Locked” Bosch MDG1 ECUs and introduces a new dedicated accessory: the KESS3 Unlock Module. This new accessory is specifically designed to perform the “Unlock” procedure directly in the workshop on MD1CS003, MD1CS069, MD1CP007, MD1 Continue Reading →
The latest Flex version 8.16.0.0 is now available, bringing new support for the Bosch MG1CA920 ECU used on BRP Group vehicles equipped with Rotax engines. With this update, Flex + Korhex extends compatibility to the new-generation SPC58N microprocessors, providing a dedicated and simplified proce Continue Reading →
