Car model and ECU type: Touran 2.0 PD AZV engine 136 LE with Bosch EDC16U1. Purpose: read and write Bosch EDC16U1 I would like to do just EGR off and Hotstart whether it should let the tools correct the checksum during the writing. 1. mpps v18 is safe on this ecu i did a hot start and popcorn li Continue Reading →
How to use Autel IM608 J2534 ECU programmer with OEM software? Here is the steps: You download the PC suite from Autel website, then run the PC suite app on your desk top. Connect your device to the computer through USB. During the process, select the following Then you use it with Continue Reading →
I just want to share my experience about buying MPPS V18. I’m trying to find a cable that I can use to read and flash the car with my Saab 9-3 1.9 TTID. If I understand correctly then MPPS V16 or MPPS V18 should work? But I did not fully understand and it didn’t say a lot about th Continue Reading →
After connecting the Autel MaxiFlash VCMI (packed with Autel maxisys ultra) to the OBD2 port of Godiag GT100, select the car model and function to be performed. Then I can see on GT100 the protocol indicator light will turn on or flash (because Autel maxisys ultra will send out the communicatio Continue Reading →
Renolink V1.87 OBD2 ECU programmer for Renault “Cannot get interface” problem & solution is provided here. Problem: My renolink 1.87 cannot work now. When I use it, an error prompt pops up “Cannot get interface” is shown as the following picture. I don’t know whether there is so Continue Reading →
Iprog+ Pro clone is a powerful ECU programmer, mainly supports IMMO, mileage correction and airbag reset till the year 2019. With 35080/160 Adapter and PCF79XX SD-card adapter, it can read, write the corresponding chip perfectly. Start with two adapters functions. 35080/160 Adapter for Iprog+ V Continue Reading →
Mini Prog is Xhorse Brand new released Handhold mutli-function Chip Programmer. It has different test head and support different adapters and cables. It work with Xhorse app Via Wifi and Bluetooth.You can use it anywhere anytime. Xhorse Mini Prog Functions: ▪Repair multiple modules ▪Data loca Continue Reading →
Problem: When I connect iProg+ Pro clone to pcf79xx adapter, and run v82 software, a message suddenly pops up “Programmer not connected” is shown as below. The possible causes: 1.The connection between iprog pro and computer or adapter is incorrect. 2.The device drive doesn’t be installed su Continue Reading →
Customer problem: when I install V1.35 software for my OEM Orange5 Plus, I always receive the prompt “USB Device Not Recognized” and “Windows no pudo instalar su orange5 USB”. I tried on many computers, but still have the error. Cardiagtool.co.uk engineer relied: The possible reason is the Continue Reading →
