Foxflash Software Update:Adds Isuzu EDC17C83 Bench/Boot Protocol
Foxflash ECU Chip Tuning Tool adds a new exclusive protocol in the newest software on May 23, 2023. After upgrade, you’ll find the BENCH protocol for Isuzu EDC17C83.
Foxflash update info:
Bench/Boot protocol for Isuzu EDC17C83.
Supported Control Units & Vehicles:
ECU:
Bosch EDC17C83 TC1793
Supported Vehicles:
Isuzu Dmax 2017-2022 1.9D 164cv
Isuzu Dmax Rodeo 2017-2022 1.9D 164cv
Isuzu M21 2017-2022 1.9D 123cv
BENCH read is real.
R/W time: ~6 minutes at first programming, then ~ 30s.
ATTENTION: Some of the latest vehicles might have a secure gateway.
Update method:
Try to update just connect, run manager and activate. No need to download, because the protocols are in the server.
If fails, run the foxFlash Manager APP, and click the Download button till all is done.
Foxflash Bench Pinout to BOSCH EDC17 C83 [1793] – Isuzu [Diesel]
Use the following driver to read and write ECU:
→ BENCH TRICORE
→ ISUZU
→ TC1793 – ISUZU
→ EDC17 C83
Foxflash Boot Mode Pinout to BOSCH EDC17 C83 [TC1793 INT.F.] – Isuzu
Read and write ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1793
To connect to the sixth pin of the micro, a Hook tweezer is recommended to use.
Foxflash ECU Programmer Earlier Update Info:
Foxflash Software Update: Boot Read & Write FCA GPEC2 GPEC3 GPEC4LM GPEC2A
FoxFlash Update in January, 2023: Adds DCM6.2A/ MED17 Series/ BMW MSV90 Boot, etc
UK Professional OBD2 Tools Online Shop