(Solved) Audi A4 1.8T 2007 Car not start after reading

Car model and year:

Audi A4 1.8T 2007 163hp

Tool to use:

Fgtech Galletto v54

FGTech-2BV54-2BGalletto-2B4-2BMaster-2BVersion-2BECU-2BProgrammer

I read this with Fgtech Galletto v54 with OBD-

1.8 Turbo 150/180CV ME7.5.1 29f400BB..galletto say change driver

1.8/2.0 Turbo 150/180CV ME7.5.5 29f800BB….read success…100% Ignition off…

Symptoms:

Will write the remap….he wants to drive off…car not start

VCDS go ECU an read fault code say “programming process not finished”

I have just read, not write…

100% working solution:

The car is running

What I did as follows:

-> I remove fuses from Dash and RadioNavi

-> use a good bosch powersupply (14V)

-> delet all fault code VCDS

-> write the same file was read before with Fgtech Galletto

-> note all prompts from galletto about ingnition on/off

-> car start….running

-> delet all fault code VCDS

This is from CAR Diagnostic Tool website Auto ECU Programmer technical support:(Solved) Audi A4 1.8T 2007 Car not start after reading