Customer problem: I want to use Foxflash ECU programmer to read and write MPC 55x/56x in BDM/Jtag mode. But when I run foxflash software, there is an error pops up “We remind you that your subscription is about to expire. Contact us to renew it…”. Eobdtool.co.uk engineer replied: It do Continue Reading →
Godiag GT107+ DSG Plus can work with foxflash ECU programmer to read DQ200 and DQ250 TCU data. It needs to set GODIAG GT107 + analog ignition switch in “manual” mode. Godiag GT107+ DSG Plus and foxflash Read DQ200: Accessories required: Godiag GT107+ DSG Plus Gearbox Data Adapter Godia Continue Reading →
One customer reported that he downloaded Foxflash Manager but he failed to open the software, and received 2 errors “Fetech data: invalid JSON primitive.” and “There is an error in XML document (1, 3).” as shown in the figures below. For this problem, eobdtool.co.uk engineer gives the follo Continue Reading →
The Foxflash ECU Programmer can support FCA GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot mode since March 14, 2023.Click here to check the detailed ECU models. Today we’ll share the Pinout to these ECUs. BAM SPC5674 CONTINENTAL GPEC2A FCA Pinout Connect with the multifunction Continue Reading →
One customer reported that he cannot read the Kia edc17cp14 by using PCMTuner with 71 module in bench mode. He tested on many ECUs but no results. Here is the suggestion from eobdtool.co.uk engineer. The following edc17cp14 pinout is for Hyundai/Kia. Do not try to read until the ID is successfu Continue Reading →
Here are three new problems and solutions for Foxflash ECU Programmer. Problems: Problem 1: Value of 25/9/2022 is not valid for “Value” Problem 2: The application was unable to start correctly Problem 3: An error occurred while trying to download file The solutions offered by e Continue Reading →
Some customers ask how to use Foxflash ECU programmer to clone Benz VGS3, Audi MED9.1, and VW MED17.1 successfully. Here are tips offered by eobdtool.co.uk engineer. 1.For Mercedes- Benz VGS3 (on bench) Use FoxFlash to copy the VIN and SCN string then write into the new VGS. And need to e Continue Reading →
Foxflash ECU programmer has been confirmed can successfully unlock VAG Simos/Siemens PCR2.1 without opening the ECU. Safe read/write/unlock on bench is the most proven way, OBD depends on VR being available. That’s ideal saves having to solder the resistors on the board!! Here is some suc Continue Reading →
Customer problem: I used Foxflash ecu programmer to do SID309 OBD password unlock stop at 57%. I waited for 20 minutes and nothing was happening. How to continue? eobdtool.co.uk engineer replied: When reading password via OBD (IN CAR), please ensure IMMO system does not become active duri Continue Reading →
