Foxflash bench box works with OBD and direct connect bench. If the bench box doesn’t have a connection, how to do a self-test? Here is the simple operation guide. 1.Connect Foxflash tool and a computer via the USB cable Connect the Bench Box to foxflash ECU programmer and power it through Continue Reading →
Is it possible to read/write Citroen C4 Spacetourer MD1CS003 ECU with Foxflash ECU Programmer via OBD? Here is the clue: 1.Before 2020 Bosch MD1CS003 BENCH! Try bench it, if locked, then no tool can do in the worldwide till now. 2.On the bench it works for sure. 3.Bench. Tested and is OK. 4.2021 Continue Reading →
The newest software of Foxflash ECU programmer was updated on September 06, 2023. It added BMW, Mini, Citroen, and Peugeot Bosch MEVD17.2.7 read and write via Bench and Boot mode. Update info: BMW MINI BENCH BOOT READ&WRITE September 06, 2023 BMW INSTALL Bosch MEVD17.2.7 Bench read/write &nb Continue Reading →
Customer problem: When I used foxflash ecu programmer to read and write ECU, the software suddenly crashed. I restarted the software to try again, but still appeared the same problem. Eobdtool.co.uk engineer’s solution: Please follow the steps below to enable Administrator elevated Privil Continue Reading →
Customer problem: I want to use Foxflash ECU programmer to read and write MPC 55x/56x in BDM/Jtag mode. But when I run foxflash software, there is an error pops up “We remind you that your subscription is about to expire. Contact us to renew it…”. Eobdtool.co.uk engineer replied: It do Continue Reading →
Godiag GT107+ DSG Plus can work with foxflash ECU programmer to read DQ200 and DQ250 TCU data. It needs to set GODIAG GT107 + analog ignition switch in “manual” mode. Godiag GT107+ DSG Plus and foxflash Read DQ200: Accessories required: Godiag GT107+ DSG Plus Gearbox Data Adapter Godia Continue Reading →
One customer reported that he downloaded Foxflash Manager but he failed to open the software, and received 2 errors “Fetech data: invalid JSON primitive.” and “There is an error in XML document (1, 3).” as shown in the figures below. For this problem, eobdtool.co.uk engineer gives the follo Continue Reading →
The Foxflash ECU Programmer can support FCA GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot mode since March 14, 2023.Click here to check the detailed ECU models. Today we’ll share the Pinout to these ECUs. BAM SPC5674 CONTINENTAL GPEC2A FCA Pinout Connect with the multifunction Continue Reading →
Here are three new problems and solutions for Foxflash ECU Programmer. Problems: Problem 1: Value of 25/9/2022 is not valid for “Value” Problem 2: The application was unable to start correctly Problem 3: An error occurred while trying to download file The solutions offered by e Continue Reading →
