One customer failed to download Foxflash software and got the error “Unhandled exception in the application. If you click Continue, the application ignores this error and attempts to continue. If you click Exit. The application will close immediately. Could not read block- no data!” He asked “ Continue Reading →
The newest software of CG100 Prog III is updated to V6.7.3.0 on Aug.29th, 2023. Here share the related update info and the available mega link to download free. CG100 PROG III V6.7.3.0 free download link: https://mega.nz/folder/3CIXXDJC#jJ4CdJ9T-eEYhkBYi6Z65A/file/DG53CA5I Update details: 1.Adde Continue Reading →
If this is your first time using Launch X-431 ECU & TCU Programmer for ECU/TCU reading/writing, data processing, anti-theft shutdown or file verification, please follow this post to download, install, update, and activate the device step by step before operation. Kindly notice: X431 EC Continue Reading →
Here is the newest customer feedback about Foxflash ECU Chip Tuning Tool. edc15 P+ BENCH Flash & eeprom Start EDC15C3 (bench)– from Renault Laguna/ Read/Write OK EDC15C13 (bench) — from Espace IV/ Read/ Write OK EDC15C4 Full Flash R/W OK – obd-bench with 12v edc15c13 renault BENCH Flash&a Continue Reading →
Use the Launch X-PROG3 PC Adaptor and X431 X-Prog3 to clone Infiniti VGS2-FDCT gearbox computer on bench, works like a charm! Here is the operation process: Connect the X-PROG3 PC ADAPTOR to the computer using a USB cable, and then connect the X-PROG3 PC ADAPTER to G3. Run X-PROG3 PC Adap Continue Reading →
This post will use different ECU programmers to read the original EEPROM & Flash data and write them into a new BMW E84 CAS3 module, and check which one is better to choose. Issue: The BMW E84 car with CAS3 module doesn’t start normally. It starts to crank the engine but stops cranking af Continue Reading →
OBDSTAR DC706 ECU Tool with P003 Adapter Kit can read/write EEPROM/Flash, and read IMMO data on VW 7GV & 9GV ECMs on bench successfully. 1.OBDSTAR DC706 R/W VW 7GV ECM on BENCH 2.OBDSTAR DC706 R/W VW 9GV ECM on BENCH All devices and accessories required: OBDSTAR DC706 hos Continue Reading →
Some customers gave feedback that Foxflash Bench Box stopped working recently. The possible cause is the relay didn’t send 12v to ECU or the P channel mosfet burned. Check the corresponding solutions below. Case 1: The relay didn’t send 12v to ECU. The relay gives power. The blue bench b Continue Reading →
Customer problem: I want to use Foxflash ECU programmer to read and write MPC 55x/56x in BDM/Jtag mode. But when I run foxflash software, there is an error pops up “We remind you that your subscription is about to expire. Contact us to renew it…”. Eobdtool.co.uk engineer replied: It do Continue Reading →
