Foxflash/New KT200 March Mega Sales at eobdtool.co.uk:
Promotion time: from March 1st to March 31st, 2023
Promotion 1: Buy Foxflash/ New KT200 with discount
Promotion 2: Buy any one Foxflash or New KT200 ECU programmer, you can get one free professional Toyota/Lexus Solder- Free Adapter (value € Continue Reading →
Sometimes, when you read the original ECU data and write into the new ECU, it may appear the issues such as the car cannot start normally, etc. Foxflash and New KT200 ECU programmer support the ECU clone function with the on-screen instruction in their own software, making the job easier. Both tw Continue Reading →
KT200 ECU Chip Tuning Tool can read Renault SID310 by OBD mode both online and offline now.
1.For online working (need internet):
You need to download and install the newest KT200 online software- V2022.12.10. It adds Renault Master SID310 via OBD and Audi MD1CP004 SPC 5777 drivers.
It’s Continue Reading →
KT200 Offline Workstation USB Dongle has been released at eobdtool.co.uk. It’s friendly for the outdoor ECU tuning where the internet is not accessible or the signal is too weak to connect, and can read & write ECU /TCU via OBD/Bench/Boot/BDM/JTAG as perfectly as KT200 online version.
Continue Reading →
Good news!!! The newest KT200 ECU programmer software V2022.12.10 has added two drivers:
Renault Master SID310 by OBD and Audi MD1CP004 SPC 5777.
How to get the new version?
1.Free Download KT200 Software 2022.12.10 online version
https://mega.nz/file/1Xk2TZKR#fp5Z14acJD4R0t0iigAguNOJ2e9mf Continue Reading →
Update! More customer feedback about which ECU can read, write and do checksum correction with KT200 ECU programmer.
Bench mode full system marelli abarth clone Ecu iate 9gf
Full backup edc16u34 audi a3 in bench mode OK
Read & write obd okey edc15p audi OK
Audi A4 Continue Reading →
Have a Volkswagen med17.5, want to read write ecu, which tool is good to use? Any advice?
Eobdtool.co.uk engineer’s suggestion:
KT200/KTM200/ECUTuner, ECU Bench Tool, and PCMTuner are good choice. All of them support VAG MED17.5 on bench and can meet your requirement.
1.E Continue Reading →
When you open KT200/KTM200/ECUTuner ECU programmer software and prompt you to update the version with the words ‘New version found, start updating’, after clicking OK, there is no response, and cannot update the new version automatically, just download and install the driver/patch by eobdtool.c Continue Reading →
Can I read this car ECU Mitsubishi E6T79990 by KT200? obd read or bench? I see in software not pinout.
Eobdtool.co.uk engineer’s answer:
Yes, this ECU is supported by KT200 ECU programmer.
It is in boot mode, check other E6TX pinouts for the same ecu pin layput, will just be Continue Reading →